Evening all
Sorry for the delay in announcing the prize choice. Been a bit under the weather for a few days.
Well as you can probably see. We didn't have that much interest in choosing the prize item.
It's between. The good old mushroom ledges or the XL ledges.
So I think it can either be the special personalised mushroom ledge in the video ( obvs with your pets name😂) or the XL ledge.
Let me know what you would prefer in the comments and I will start the competition later in the week.
A new era of personalised ledges is upon us.
These can be made from any of the colours in our range.
There would be an extra charge of £4 for personalising ledges. These would probably still be cheaper than some of the stuff found on Etsy or eBay.
Is this of interest to you lovely lot?
Think I have finally cracked it😁
They Do require a bit of effort to get in but they do go and they do hold.
Snake Orb version 3
This version has a locating lug and a magnet on each side which are glued in place.
I felt the previous version snapped together too harshly which could cause injury. This version is a bit more gentle.
These would cost £16 and are suitable for various small snake species.
Feedback on design and price very much appreciated😁
Please share with your snake keeping friends.
Snake ball V2. This one is slightly larger and has 3cm holes and is approximately 13.5cm diameter.
As you can see this one splits in two to allow the easy removal of your snake if they are in a stubborn mood.
I may change the way the magnets are and just glue them into holes as it would be easy to mess putting the magnets in and scrapping the print.
Please ignore the slight colour change. I just just using up some end of rolls and they can have slightly different colours between batches.
So is this and the smaller version of interest to the snake keepers?
I was asked about making these ages ago but just didn't get around to it.
Well I just got around to it😁
Is there a call for them?
Plant clamp for adding terrestrial plants to an open top aquarium.
Plants like phothos are fantastic at removing Nitrates from the water.
These can be made for 6mm, 8mm, 10mm and 12mm thick glass.
Has two as lots for larger or smaller stems.
Feedback much appreciated
I will just leave this here.
Feedback very much appreciated
A customer wanted to try something for enriching the environment of small/hatchling snakes.
This is what I've come up with. It's only a prototype at the moment but I will be sending it to the customer this week to trial.
The feet are to be buried in the substrate for extra stability.
What do we all think?
Had a bit of time for a change.
So I've come up with this multi hide for the micro/Mourning geckos.
Has 4 little hidey holes.
Is this something that will interest people?
Anything that could be changed?
Feedback much appreciated.
